AMI BIOS options

Caute.
Neviem, ci to tu bolo, ale nikde som to nenasiel.
Potrebujem flashnut bios od AMI na zakladnej doske MSI K9N Sli Platinum a neviem ake options by som mal zadat pri flashovani. Konkretne je to flashovaci program Afud408.exe.
Niekde som nasiel kombinaciu /P /B /N /C.
Mohol by niekto dat aj popis jednotlivych moznosti?

Dik.

+---------------------------------------------------------------------------+
| AMI Firmware Update Utility Ver.4.xx |
| Copyright (C)2007 American Megatrends Inc. All Rights Reserved. |
+---------------------------------------------------------------------------+
| Usage: AFUWIN <ROM File Name> [Option 1] [Option 2]... |
| or |
| AFUWIN <Input or Output File Name> <Command> |
| or |
| AFUWIN <Command> |
| ------------------------------------------------------------------------- |
| Commands: |
| /O - Save current BIOS into file |
| /U - Display ROM file's ROMID |
| /Ln - Refer to Options: /Ln |
| /M - Refer to Options: /M |
| /MAI - Disaply System ROM and ROM file's MA information |
| /HOLE: - Update specific ROM Hole according to given name. |
| NewRomHole1.BIN /HOLE:RomH1 |
| /HOLEOUT: - Save specific ROM Hole according to given name. |
| NewRomHole1.BIN /HOLE:RomH1 |
| /D - Verification test of given ROM File without flashing BIOS. |
| /EC - Flash EC firmware BIOS (Refer to OFBD Spec) |
| /NCB - Flash NCB Area (Refer to OFBD Spec) |
| /NCBOUT - Output NCB Data according to given name. |
| Options: |
| /P - Program main BIOS image |
| /B - Program Boot Block |
| /N - Program NVRAM |
| /C - Destroy CMOS checksum |
| /E - Program Embedded Controller Block |
| /K - Program all non-critical blocks |
| /Kn - Program n'th non-critical block only(n=0-7) |
| /Q - Silent execution |
| /REBOOT - Reboot after programming |
| /X - Don't Check ROM ID |
| /S - Display current system's ROMID |
| /Ln - Load CMOS defaults:(n=0-3) |
| L0: Load current optimal |
| L1: Load current failsafe |
| L2: Load optimal from ROM file |
| L3: Load failsafe from ROM file |
| /M - Update bootblock MAC address if it exists |
| Example: /M1234ABCD will update MAC to 1234ABCD |
| /R - Preserve ALL SMBIOS structure during NVRAM programming |
| /ECUF - Update EC BIOS when newer version is detected. |
| /SHUTDOWN - Shutdown after programming. |
+---------------------------------------------------------------------------+


Pre bežný flash stačí napísať -> Afud408 "názov biosu", nemusíš sa zaťažovať prepínačmi

Myslel som skor vysvetlenie, co na co sluzi, toto som si aj ja precital.
Netreba ziadne prepinace? Tak to som rad.
Idem to flashovat z USB.

na usb hod tvoj bios v tvare nazov biosu.rom a pri starte stlac F2 ... samizda, blizsie je to rozpisane v kat. OC

Ja som nasiel program, ktory spravi USB bootovatelne s DOSom, aj som to skusal a islo to ale napisat tam subory s flashom som sa bal
Ktora metoda je lepsia?
Dik za tip.